Uniflame GBT1111W Manuel du propriétaire télécharger pdf (Page 9)

Contact 1.800.762.1142 for assistance. Do not return to place of purchase.

page no.

Troubleshooting

Problem Possible Cause Prevention/Cure

Burner will not light using ignitor

(if included)

LP gas tank is low or empty Replace LP gas tank

LP gas leak Follow “Checking for Leaks” instructions in the owner’s manual

Wires or electrode covered with cooking residue Clean wire and/or electrode with rubbing alcohol

Electrode and burners are wet Wipe dry with cloth

Electrode cracked or broken - sparks at crack 2EPLACE ELECTRODE PLEASE CALL OUR #USTOMER #ARE AT 

Wire loose or disconnected

Reconnect wire or replace electrode/wire assembly, please call our Customer

#ARE AT 

Wire is shorting (sparking) between ignitor and electrode

Replace ignitor wire/electrode assembly, please call our Customer Care at



Bad ignitor 2EPLACE IGNITOR PLEASE CALL OUR #USTOMER #ARE AT 

Burner will not light with match

No gas flow

Check if LP gas tank is empty

A. If empty, replace

B. If LP gas tank is not empty, refer to “Sudden drop in gas ﬂow or reduced

ﬂame height”

LP gas tank is low or empty Replace LP gas tank

LP gas leak Follow “Checking for Leaks” instructions in the owner’s manual

Coupling nut and regulator not fully connected

Turning the coupling nut about one-half to three quarters additional turn until

solid stop. Tighten by hand only-do not use tools

Obstruction of gas flow Clear burner tubes, per cleaning instruction on www.bluerhino.com

Spider webs or insect nest in venturi Clean venturi and burner tube, per cleaning instruction on www.bluerhino.com

Burner ports clogged or blocked Clean burner ports, per cleaning instruction on www.bluerhino.com

Sudden drop in gas flow or reduced flame height

Out of gas Replace LP gas tank

Excess flow valve tripped; safety device may have been

activated

 4URN REGULATORCONTROL KNOB TO “OFF

”

 7AIT  SECONDS AND LIGHT GRILL

3. If ﬂames are still too low, reset the excessive ﬂow safety device:

a. Turn regulator/control knob “OFF

”

b. Remove LP gas tank

C 7AIT  MINUTE

d. Attach LP gas tank

e. Perform a leak check per “Checking for Leaks” instructions in the owner’s

manual

f. Light grill per “Lighting Instructions” instructions in the owner’s manual

Irregular flame pattern, flame does not run the

full length of burner

Burner ports are clogged or blocked

Clean burner ports, per cleaning instruction on www.bluerhino.com

Flame is yellow or orange

New burner may have residual manufacturing oils

"URN GRILL FOR  MINUTES ON

(HIGH) with the lid closed

Spider webs or insect nest in venturi Clean venturi, per cleaning instruction on www.bluerhino.com

Food residue, grease, etc. Clean burner, per cleaning instruction on www.bluerhino.com

Poor alignment of valve to burner venturi Assure burner venturi is properly engaged with valve

Flame blow out

High or gusting winds Do not use grill in high winds

Low on LP gas Replace LP gas tank

Excess flow valve tripped; safety device may have been

activated

Refer to “Sudden drop in gas flow or reduced flame height”

Flare-up

Grease buildup

Remove and clean all grill parts per “Cleaning and Care” instructions in the

owner’s manual

Excess fat in meat Trim fat from meat before grilling

Excessive cooking temperature Adjust (lower) cooking temperature

Persistent grease fire

Grease trapped by food buildup around burner system

 4URN CONTROL KNOB TO “OFF

”.

2. Leave lid in closed position and let ﬁre burn out

3. After grill cools, remove and clean all parts per “Cleaning and Care”

instructions in the owner’s manual

Flashback (fire in burner tube(s))

Burner and/or burner tubes are blocked

Clean burner and/or burner tube, per cleaning instruction on www.bluerhino.

com

Inside of lid is peeling (like paint peeling)

The lid is stainless steel, not painted

Baked on grease buildup has turned to carbon and is flaking off, clean

thoroughly per “Cleaning and Care” instructions in the owner’s manual

The lid is coated/painted

This can be from baked on grease buildup, that has turned into carbon and is

flaking off.

Clean thoroughly, per “Cleaning and Care” instructions in the owner’s manual

After cleaning, if you can see steel, please call out Customer Care at



For more assistance please visit us online at www.bluerhino.com or call 1.800.762.1142.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Uniflame GBT1111W Manuel du propriétaire Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Barbecues et grillades Uniflame GBT1111W